anguspaws

Does anyone know what size and or model belt is needed to run stock pulleys (alt) without the air pump? I am downgrading from the aftermarket pulleys and the belt is a little to large.

phoenix7

for your water pump:
http://www.pineappleracing.com/index...PROD&ProdID=39

is this what you're asking for?

twomucboost4u

iTrader: (9)

300mm or 30 inch 4 rib. they are hard to find though so you might have to run a 3 rib. At least i think thats what i remember it being.

Chris

anguspaws

The one that is on there is 5rib and the size is unknown because all numbers have worn off.

cozmo kraemer

I have about every size it could possibly be sitting in my car right now. If you want to wait until the dyno day in so cal I could sell you which ever one fits your application for the price I paid for it. I believe I have a 295 a 300 and a 305 all in 4 rib.

GoRacer

iTrader: (2)

It's about a 28" belt. 27 & 3/4" is too small and 28 & 3/4" is too long, so forget about 29" which looks to be right since it's easier to install but you won't be able to tighten it enough.

The problem you will have is the belt will slip since there won't be enough tension which is why the pulley kits have a larger tension wheel. There's a better explenation on Pineapples web site.