Looking for someone to part out a car near I.E.
Trending Topics
03-02-06, 01:36 PM
#12
Slizzard sippin sizzurp
iTrader: (4)
Join Date: Jul 2001
Location: Cali
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by GUITARJUNKIE28
don't take glenn's car apart!!!!!!
03-02-06, 01:48 PM
#14
Slizzard sippin sizzurp
iTrader: (4)
Join Date: Jul 2001
Location: Cali
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
Damn, cracked the front iron? Not cracking the bridge I'm assuming, but cracking near the dowels? That really sucks. Its still a good setup though, just throw some S5 irons in there and you're good to go.
03-02-06, 03:24 PM
#15
S2K
Thread Starter
Join Date: Jul 2003
Location: Irvine, CA
Posts: 1,116
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, I think I will part it out and take a break from rotaries for a long time. I only drove it for less than 150 miles, and most of the time I was just cruising around town with no boost.
03-02-06, 04:12 PM
#20
multipersonality disorder
Join Date: Feb 2002
Location: so. cal
Posts: 5,656
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by mazpower
Damn, cracked the front iron? Not cracking the bridge I'm assuming, but cracking near the dowels? That really sucks. Its still a good setup though, just throw some S5 irons in there and you're good to go.
yea, cracked right at the top dowel. not bad for an s4 iron though. if he ends up rebuilding it, he might just go with stock, or a little streetport.
Just junk it and save $$$$$$. And yes, I have a free towing service.