Think I messed anything up?
#1
Think I messed anything up?
Worked on the FC all day today and decided to have some fun tonight.
Took her drifting in some parking lots, then when I was leaving theres this roundabout paved with these slick bricks and I got it going and the front pushed out and I ran into the ouside curb.
Since the wheel was turned and I hit at an angle the wheel was pretty much parallel with the curb.
So I looked and like 6 inches of the lip of my rim is bent in. I'm more worried about all the steering parts though. The tie rod and A arm looked good, but is there anything specifically I should check. It pulls to the right now too. (I hit the right side). I'm going to allign it in my auto class at school wendsday.
Also, if I take the tire off and use a mallet or something to fix the lip, is it going to be weak from being bent back and forth or should it be good?
Thanks for the help guys.
Took her drifting in some parking lots, then when I was leaving theres this roundabout paved with these slick bricks and I got it going and the front pushed out and I ran into the ouside curb.
Since the wheel was turned and I hit at an angle the wheel was pretty much parallel with the curb.
So I looked and like 6 inches of the lip of my rim is bent in. I'm more worried about all the steering parts though. The tie rod and A arm looked good, but is there anything specifically I should check. It pulls to the right now too. (I hit the right side). I'm going to allign it in my auto class at school wendsday.
Also, if I take the tire off and use a mallet or something to fix the lip, is it going to be weak from being bent back and forth or should it be good?
Thanks for the help guys.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM