Hey guys, looking for some input before i place an order on my wheels. Currently will be installing a RE-Amemiya GT-AD II Kit and looking at the following:

Work CR Ultimate Kiwami's:

Fronts: 18x9.5 +20 mm offset tire size: 255/35/18
Rears: 18x10.5 +15 mm offset tire size: 285/30/18

My question is, does anyone know if these will fit correctly with the kit? And if the rear 18x10.5 +15 will fit the rears without cutting the rear fender? I was hoping id be able to fit them with rolling the fender.

Any input would be greatly appreciated!

 

If you're installing the AD GT wide body kit as well, then you're likely will have to cut to fit the rear wide fenders. So there is no "rolling" fenders because it's fiberglass

 

The Re-Amemiya Rear fenders rivet on to the existing fender. I know a few people who were able to roll the stock fender and fit the fender over. I am just trying to get some confirmation to make sure this will fit.

 

I'm running 18x10.5 +20 with a 295/30 tire, even with the roll and light pull, the wheel was still past the fender. I've now added FEED rear fenders and the tire sits just right.

 

I think I have it figured out. Since there doesn't seem to be a lot of info on this i ended up going with the following:

WORK CR Ultimate Emotion Kiwami

Fronts: 18x9.5 +20 (255/35/18)
Rears: 18x10.5 +15 (295/30/18)

Tires are Yokohama NEOVA AD08 R

 

curious, what part of Massachusetts are you from?

 

Quincy, MA