Anyone have pictures of FC with enkei Rpf1???

i remember a red GTUs with 17" it looked really nice...

 

I'm pretty sure that was Rishie's (ARD T2's) car. Here's my old FC on the wheels I bought from him.

 

can i fit 17x9.5 around with rolled fenders front and back?

 

Nice, want size are they?(rims and tires)

Thanks

 

Bluem, I'm not sure, but if you PM ARD T2, I'm sure he can point you in the right direction. He's the resident wheel guru.

90FC, they're 17x8f and 9r, wrapped in 235-40f and 245-40r BFG KDWs. The 8's in front are nice because the spoke pattern makes plenty of room for a big brake kit. See how the spokes stick out a little bit compared to the rears?

 

picture:
https://www.rx7club.com/midwest-rx-7-forum-32/no-rear-side-maker-illegal-695963/

RPF1 SBC finish 17x9.5+18 (f&R) fronts have 3mm spacer due to my wide tires. 255/40 on all four. wide fenders required front and back, some negative chamber up front with coilovers. If you don't have the power, don't do it. So, yes it is possible...

 

Direct linkage FTW! lol.

That's shiny.


Heh, so shiny that it looks like someone's leaning on your fuel filler door.

 

have any pics of the rest of the car? ; )

 

Here ya go

 

nice

 

just for reference, 17x9 +22 front 17x10 +18 rear

 

thanx! turbo23

im looking for a set up that can use the same wheel on all 4's maybe 17x9.5 all arround, this way i can rotate the tires between heats , i can only use 6 new stiker tires per race and 2 used tires.

will i be able to fit 17x9.5 all round with the same tire size with rolled fenders?

 

errr fronts would be very tough to fit. Even with a roll, you could probably pick up some wide front fenders. Rears would be fine

 

you should run the 17x9 +22 or +15 all around if you need ONE wheel size for all four corners.

those are such nice wheels!

Turbo23, you need to take even more pics

 

haha I will, I just made a new hood, so once the hood is painted, Ill be sure to take some decent pics, and maybe a video or 2

 

cool, more pics would be great. your FC just has the right look to it. nice work.


here is ARD T2s FC on an 18" rpf1 setup, cant remember if this was his stretchy or grippy fitment...

so clean!