Eibach Springs installed
08-15-04, 01:08 PM
#1
Rotary Freak
Thread Starter
iTrader: (6)
Join Date: Jan 2002
Location: Golden, CO
Posts: 1,807
Likes: 0
Received 0 Likes
on
0 Posts
Eibach Springs installed
Well 2 days, many beers and much cursing later, I've got my Eibach springs installed. I used http://www.scuderiaciriani.com/rx7/s...tallation.html (much thanks!)
Counting the time spent going back and forth to Sears to replace broken tools and to buy correct 1/2" sockets, I think it took me about 7 1/2 hours all together. This is the biggest project I've tackled so far, previously only done oil changes, brake lines and brake bleeding.
Car feels much stiffer now, turns in better, but I need to get it aligned. Anyone know of a good shop in the VA/MD/DC area?
Much thanks to the board again, I couldn't have done this without the weath of information here!
Joe
Counting the time spent going back and forth to Sears to replace broken tools and to buy correct 1/2" sockets, I think it took me about 7 1/2 hours all together. This is the biggest project I've tackled so far, previously only done oil changes, brake lines and brake bleeding.
Car feels much stiffer now, turns in better, but I need to get it aligned. Anyone know of a good shop in the VA/MD/DC area?
Much thanks to the board again, I couldn't have done this without the weath of information here!
Joe
Thread
Thread Starter
Forum
Replies
Last Post
NCross
2nd Generation Specific (1986-1992)
9
09-03-15 03:42 PM