1st Gen RX7 Tie Rod taper same as FC?
#1
Full Member
Thread Starter
1st Gen RX7 Tie Rod taper same as FC?
Hi all,
Would someone be able to tell me if the outer tie rods from an FC RX7 match the steering arm of a 1st Gen RX7? If a first gen owner happens to have some FC steering bits laying around and could slide the FC tie rod into the SA/FB steering arm I would very much appreciate the help!
I know the threads are different - 1st Gen outer has M14 x 1.5 Left hand, 2nd Gen has M12 x 1.5 Right hand.
I want to know if the tapers are the same or close enough to being the same? I think Miata/MX5 and Nissan 200 SX are close to FC also, shown here:
Miata, S13, FC RX-7 OuterTie Rod Interchangability. - Miata Turbo Forum - Turbo Kitten is watching you test compression.
Thanks in advance,
Arran
Would someone be able to tell me if the outer tie rods from an FC RX7 match the steering arm of a 1st Gen RX7? If a first gen owner happens to have some FC steering bits laying around and could slide the FC tie rod into the SA/FB steering arm I would very much appreciate the help!
I know the threads are different - 1st Gen outer has M14 x 1.5 Left hand, 2nd Gen has M12 x 1.5 Right hand.
I want to know if the tapers are the same or close enough to being the same? I think Miata/MX5 and Nissan 200 SX are close to FC also, shown here:
Miata, S13, FC RX-7 OuterTie Rod Interchangability. - Miata Turbo Forum - Turbo Kitten is watching you test compression.
Thanks in advance,
Arran
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM
craaaazzy
Comments and Suggestions Archive
3
08-21-15 02:00 PM