Super AFC hooking up SAFC to run MAP instead of TPS
#2
Rotary Freak
iTrader: (1)
You need to use the gray wire coming out of the SAFC (the same one that is hooked up for TPS signal). It hooks up to the boost sensor output BEFORE THE FCD. For s4 it is a BROWN WIRE WITH A RED STRIPE, FOR s5 it would be GREEN WIRE WITH YELLOW STRIPE.
Change sensor type to pressure from TPS.
Change sensor type to pressure from TPS.
#3
Card-carrying Rotorhead
Join Date: May 2006
Location: Quebec
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
I have the same question except I'm using all s4 na (ECU, harness, etc.). I'm thinking about using a GM 3-BAR map sensor as the boost signal input. Is it just as simple as wireing the sensor to the grey wire?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
82streetracer
Haltech Forum
11
03-11-19 05:34 PM
befarrer
Microtech
3
08-22-15 05:52 PM