Tuning GT4088R, what to tell the tuner, what to expect.
#28
Did you choose to ignore the port on the front iron? You can see where the side seals were hitting the top of the port. Also that is some of the ugliest porting I have seen a good while. Those irons look really rough in general. Send it to Howard with a better/new set of irons and let him handle it for you.
#29
Full Member
Thread Starter
iTrader: (8)
Join Date: Apr 2004
Location: tusin Ca
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
I don't really know port work at all. I didn't want to call out the shop signed off on the ports. But some of you have figured out.
Instead of trying to fiddle with those irons again.
I am sending Howard my spare jdm block and the new rotor housings that were on the motor that lost a side seal.
Sending him an extra rear iron because i messed up.
I'm all packed and ready to go.
Instead of trying to fiddle with those irons again.
I am sending Howard my spare jdm block and the new rotor housings that were on the motor that lost a side seal.
Sending him an extra rear iron because i messed up.
I'm all packed and ready to go.
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM