T4 Foot print?
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2001
Location: UK
Posts: 1,271
Likes: 0
Received 0 Likes
on
0 Posts
T4 Foot print?
Is it possable to fit a T4 Turbine housing to a Gt3540? I would like to keep the T4 foot print to save messing about with my manifold or is the next one up the Gt40/42 a T4 foot print? and if so would it be too big for a Rx?
What i would like is a Dubble BB Turbo some where between a GT3540 and the T66 but i dont want to be messing with my Manifold as its not that old?
Thanks.....Chris
What i would like is a Dubble BB Turbo some where between a GT3540 and the T66 but i dont want to be messing with my Manifold as its not that old?
Thanks.....Chris
#2
You can technically mate a T4 housing to the GT35/40 CHRA, but I found the housing I had (spare) in the garage is too big for the turbine wheel of the GT35. So, it probably wouldn't make any power.
I don't think I found a T4 housing that would fit nicely with the GT35, but I didn't spend too much time on it either.
J
I don't think I found a T4 housing that would fit nicely with the GT35, but I didn't spend too much time on it either.
J
#4
Rotary Enthusiast
Join Date: Feb 2001
Location: The First State
Posts: 1,375
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Grizzly
Am i better looking at somthing like a T66 BB or the next one up GT4042 than trying to adapt a GT3540?
Am i better looking at somthing like a T66 BB or the next one up GT4042 than trying to adapt a GT3540?
Thread
Thread Starter
Forum
Replies
Last Post
NLPerformance
1st Generation Specific (1979-1985)
26
10-10-15 08:59 PM