Spark Plug Wires
#1
Rotary Enthusiast
Thread Starter
Join Date: Oct 2002
Location: S.Cali, OC!
Posts: 1,468
Likes: 0
Received 0 Likes
on
0 Posts
Spark Plug Wires
Hey guys, finally started working on my FD again.
And one thing i noticed when i was putting the whole thing back together was one of my trailing magnecor sparkplug wire clips is broken on the inside, so it isnt cliping onto the sparkplug.
I am running 9s in trailing and leading and a crane ignition amp. Im going with a Garrett T04S T61. Running about 1 bar. Shooting for 350-400 whp.
Are the stock NGK plug wires good enough for this setup. I found them for like $30?
Should i get magnecor again?
or Jacobs from Rx7.com i saw for $40?
Any other suggestions for good cost effective plugwires?
Thanks guys!
And one thing i noticed when i was putting the whole thing back together was one of my trailing magnecor sparkplug wire clips is broken on the inside, so it isnt cliping onto the sparkplug.
I am running 9s in trailing and leading and a crane ignition amp. Im going with a Garrett T04S T61. Running about 1 bar. Shooting for 350-400 whp.
Are the stock NGK plug wires good enough for this setup. I found them for like $30?
Should i get magnecor again?
or Jacobs from Rx7.com i saw for $40?
Any other suggestions for good cost effective plugwires?
Thanks guys!
Thread
Thread Starter
Forum
Replies
Last Post