Post Your Single Turbo Setup.
#726
KKK K27-7200 Turbo - 14psi
Standard port 13b on 98octane with compression in the high 4s
Aem WI
550/1650s
pfc and map
400hp and 365lbft
In for a rebuild now so will update in due course.
Standard port 13b on 98octane with compression in the high 4s
Aem WI
550/1650s
pfc and map
400hp and 365lbft
In for a rebuild now so will update in due course.
#728
Rotary Enthusiast
iTrader: (5)
Same old set up..
BW 362 sxe 1.0 ar ceramic coated
very old long run turblown mani
dual open waste gates
Primary injectors 1000 ID
Secondary injectors 2000ID
FFE fuel rails
walbro 450 fuel pump
Excessive LIM ceramic coated
OMp deleted( pre-mixing)
93 octane (pump gas only)
393 whp on Dyno Dynamics Dyno @
13 psi
ETS 4" intercooler set up as V-mount
fluidyne rad.
hks twin power.
10 and 9 spark plug heat temp
3" exahust
BW 362 sxe 1.0 ar ceramic coated
very old long run turblown mani
dual open waste gates
Primary injectors 1000 ID
Secondary injectors 2000ID
FFE fuel rails
walbro 450 fuel pump
Excessive LIM ceramic coated
OMp deleted( pre-mixing)
93 octane (pump gas only)
393 whp on Dyno Dynamics Dyno @
13 psi
ETS 4" intercooler set up as V-mount
fluidyne rad.
hks twin power.
10 and 9 spark plug heat temp
3" exahust
The following users liked this post:
alex_ptolemaida (12-12-19)
The following users liked this post:
Slides (12-19-20)
The following users liked this post:
AndyMcfly (12-20-20)
#739
Senior Member
Join Date: Jun 2010
Location: U.K - Instagram - copyninja_fd
Posts: 302
Received 141 Likes
on
81 Posts
Engine - Large street port, studded and balanced with RA super seals - 8000 rpm max rev limit.
Turbo - Garrett TO4Z 1.00 AR
Power - 390 bhp at flywheel
Boost - 0.7 bar of boost
WMI - No
Torque - 316 lb ft at flywheel
Weather conditions - Wet
Gearbox - Oem 5 speed manual
Final drive - 4.44
Wheels and Tyres - Advan RG2 17 x 9 All round. Michelin Pilot Sport 4 with 245 40 17s all around.
Only mapped on low boost at 0.7 bar running 390 bhp and 316 lb ft at the flywheel.
In a few weeks with water injection it will be mapped to 1.2 bar and hopefully make close to 500 bhp.
Made 390 bhp and 316 lb ft at the flywheel
60-100mph in 4.46s (wet conditions)
60-130mph in 10.55s (wet conditions)
Turbo - Garrett TO4Z 1.00 AR
Power - 390 bhp at flywheel
Boost - 0.7 bar of boost
WMI - No
Torque - 316 lb ft at flywheel
Weather conditions - Wet
Gearbox - Oem 5 speed manual
Final drive - 4.44
Wheels and Tyres - Advan RG2 17 x 9 All round. Michelin Pilot Sport 4 with 245 40 17s all around.
Only mapped on low boost at 0.7 bar running 390 bhp and 316 lb ft at the flywheel.
In a few weeks with water injection it will be mapped to 1.2 bar and hopefully make close to 500 bhp.
Made 390 bhp and 316 lb ft at the flywheel
60-100mph in 4.46s (wet conditions)
60-130mph in 10.55s (wet conditions)
Thread
Thread Starter
Forum
Replies
Last Post
badass7
3rd Generation Specific (1993-2002)
1
09-19-03 01:39 AM