Is it possible to connect a PCV valve with a single turbo setup?
Thread Starter
Joined: Jul 2007
Posts: 1,370
Likes: 13
From: Trois-Rivieres (QC)
Is it possible to connect a PCV valve with a single turbo setup?
Hello guys,
1992 JDM FD.
I know the top nipple on the oil filler neck goes to UIM... However, where can I connect that bottom nipple? There is no other nipple that big available on the UIM...
1992 JDM FD.
I know the top nipple on the oil filler neck goes to UIM... However, where can I connect that bottom nipple? There is no other nipple that big available on the UIM...
Last edited by MuRCieLaGo; Jun 30, 2022 at 10:08 PM.
Joined: Mar 2001
Posts: 31,835
Likes: 3,233
From: https://www2.mazda.com/en/100th/
i just tapped a fitting on the pipe in front of the turbo, super easy. the oil change place overfilled the oil, so i can confirm that its working, lol
plan B, if its an FD you could probably just run the PCV from the oil filler neck to the upper intake, a stock FD actually runs both (except the US 1995's)
plan B, if its an FD you could probably just run the PCV from the oil filler neck to the upper intake, a stock FD actually runs both (except the US 1995's)
Thread
Thread Starter
Forum
Replies
Last Post