Single Turbo RX-7's Questions about all aspects of single turbo setups.

old leaking primaries

Thread Tools
 
Search this Thread
 
Old Mar 2, 2008 | 07:03 AM
  #1  
drifting in drifting's Avatar
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
old leaking primaries

Will the primary injectors out of my 87 n/a work in my 87 t2
Reply
Old Mar 2, 2008 | 01:17 PM
  #2  
svo855's Avatar
Junior Member
 
Joined: Jan 2007
Posts: 6
Likes: 0
From: Dallas
They will fit in the same spot but they flow 16% less fuel. You are asking for problems.
Reply
Old Mar 2, 2008 | 01:22 PM
  #3  
mazda_wes's Avatar
404** File not Found
iTrader: (6)
 
Joined: Feb 2008
Posts: 399
Likes: 0
From: houston
you could get the temporary fixes from mazdatrix until you could find a set of primaries for cheap.
Reply
Old Mar 2, 2008 | 04:59 PM
  #4  
Rotary_Rocket_87's Avatar
2nd Gen. Enthusiast
Tenured Member 05 Years
 
Joined: Feb 2006
Posts: 388
Likes: 0
From: New Hampshire
Don't do it. I put a set of na injectors in my t2 (primaries) and all it did was putt along at 5 MPH. I only went around the block, so no damage was done before I put the t2 injectors back in.

On a side note I am running na injectors for the secondaries. I don't recommend this at all, it just so happens that it helped my car stop running pig rich. My stock injectors are probably in dire need of being cleaned, and the NA injectors were just cleaned before installation. The 16% drop in flow hasn't affected my car (other than helping my AFR) negatively.

AGAIN I DON'T ADVISE ANYONE TO USE SMALLER INJECTORS.
Reply
Old Mar 2, 2008 | 05:57 PM
  #5  
drifting in drifting's Avatar
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
ok so 550 are stock right high or low??
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM
eplusz
General Rotary Tech Support
15
Oct 7, 2015 04:04 PM




All times are GMT -5. The time now is 10:42 AM.