New 62-1, what to expect?
Thread Starter
Joined: May 2003
Posts: 1,428
Likes: 0
From: Marion, Ohio
New 62-1, what to expect?
Well, I just got my new Turbonetics 62-1 and almost everything else I need to get it running again. I know there are a million threads like this, but what can I expect HP and spool-wise? Its a conventinal bearing turbo, .96 turbine housing, P trim wheel. Most likely getting the turbine housing jet hot 2000 coated and the compressor housing extrude honed. Im going to be running 16-17 psi with water injection. Mods are in sig, plus several others that are coming like the MazdaRacing comp pulley system, some kind of ignition upgrade, cooling mist kit, and several others. Streetport is a "stage 2" from rx7store, with RA seals.
Purty!
Expect 10 psi around 3500~4300rpm and putting down 380~430 whp @ 1 bar (14.7 psi) (sorry for the large range but its dependant on porting and tune amoungst MANY other variables).
FWIW, you'll see much more gains extruding your turbine housing then your comp housing.
~Mike...................
Expect 10 psi around 3500~4300rpm and putting down 380~430 whp @ 1 bar (14.7 psi) (sorry for the large range but its dependant on porting and tune amoungst MANY other variables).
FWIW, you'll see much more gains extruding your turbine housing then your comp housing.
~Mike...................
Resident Retard
Joined: Apr 2001
Posts: 1,918
Likes: 0
From: Cockaigne
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM