need some advice
05-23-02, 06:23 PM
#1
need some advice
i'm installing an apexi rx6 , so far the motor is stripped down to the block, all emission equipment removed. i relocated the coil rack to the frame and wrapped the harness with cool tape. i need to know if u guys think i should wrapped the stainless steel manifold with HEADER WRAP, i'm trying to create a fast reliable car that quiet and streetable. apexi gt spec for sale soon
05-23-02, 06:57 PM
#2
MAGNUM SE7EN
iTrader: (11)
Join Date: Mar 2001
Location: Asheville, NC USA
Posts: 1,427
Likes: 0
Received 0 Likes
on
0 Posts
I think the best bet would be ceramic coating. I have "heard" header wrap can trap moisture against the metal, although this may not be an issue since its ss. Bottom line is I don't have a clue but felt like I should respond with a recommendation on ceramic coating 
Best of luck!
Best of luck!
05-23-02, 09:01 PM
#4
MAGNUM SE7EN
iTrader: (11)
Join Date: Mar 2001
Location: Asheville, NC USA
Posts: 1,427
Likes: 0
Received 0 Likes
on
0 Posts
www.jet-hot.com
I inquired about getting my downpipe coated and a week or so later I received a packet of info in the mail containing a video on the process and tons of info and a couple of stickers.......haha.
I inquired about getting my downpipe coated and a week or so later I received a packet of info in the mail containing a video on the process and tons of info and a couple of stickers.......haha.
Thread
Thread Starter
Forum
Replies
Last Post
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM