I just purchased an aeromotive FPR for my Fd and i dont know were to mount it. Can anyone give me any tips on how to mount this thing. Also If there are any brackets of fittings i can pick up at homedepote please let me know. Thanks

 

bump

 

I'll mount it at back of engine bay

 

I see but how is that going to fit between the engine and the firewall. Thats my problem.

 

mine is mounted to the upper intake manifold on the piece that use to hold the twin turbo solenoids! i just drilled a small hole threw it and a small nut and bolt

 

with the right fittings you can make it fit

 

I did the same thing as FD Rey did.



There's the small bar on the UIM in the front that can be used for mounting.

I created a small bracket, drilled and tapped that small bar and bolted the bracket to it. I then bolted up the FPR to the bracket. One trick for my setup was that there's two small screws in the back of the FPR that mounts the bracket. I drilled 2 holes in my bracket so I can get an allan wrench in to put it on.



More pictures here: https://www.rx7club.com/showthread.p...3&page=2&pp=40

 

Here is how mine is mounted.