Ok here's the deal. This Fri i will take my car to the Dyno and get it tuned. Guess How much HP to the wheels i'll make without going over, and i'll give you..... I don't know - something. and a pat on the back, and the bragging privelages that you know what you're talking about. For a hint here are my mods: (@ 18lbs & NO N2O)

Street port S/5 engine. agresive port.
TO4B 1.15 A/R Turbine, P-trim. 60-1 Hi-Fi.
3" turbo back exhaust. Borla XR-1 presilencer Apex'i N1
Greddy FMIC, Profec-B
RP comp fuel pump, 1600 cc secondaries, SX fuel pressure regulator.
Ceramic coated intake manifold.
RP comp pulleys
E-fan
Manual steering rack
Haltech E6K

Good luck!

 

18psi pump gas or race gas? and what A/F ratio?

I'll say around 360rwhp and 330rwtq.

 

I have a hunch that it'll be 434 at the wheels. Dunno why 434, but i trust my hunches

 

it 's an 89 by the way
Gas? yeah that's a big difference......bean burrito gas
No just the pump gas that's available in daytona 93 Octane

In case of a tie, your guess of TQ will break that.

 

A/F ratio? Hmmm i don't really know. something meaty but not overboard.

 

This is a street car, not just a drag sled

 

387 rwhp 331 tq

 

whos tunning the car???

 

381.5 - 398.7

 

435hp @ 2 lb torque

 

Scott @ Mazsport in largo Fl is doing it. Don't know him personally, but i've heard good things about him. I think i'll have Chris tune the nos when it's completed. then i'll probably throw another one of these.

 

407rhp and 374 tq and If I right I'll skip the pat on the back and you can just give me your engine. I'll PM you my address so you can ship it out later friday after noon

 

418RWHP and more torque than a room of females

 

454

 

 

328hp @ 7000rpm, 290 lbs-ft @3800 rpm

 

I said 367 hp on the other fourm. I'll go with 328 ft/lbs torque.

 

Are you copying me??? j/k

 

438

 

no dice on the dyno tuning. I developed a oil leak at the oil return line. It's just the gasket so i don't think it should a problem to fix. I think i'll make my own gasket. Any recommendations for gasket material and where to get it. I'm thinking something asbestos based, since it doesn't readily burn and withstands high heat.

 

high temperature sealant, works everytime

exhuast gasket sealant should do.......

 

Id say 365rwhp and about 335rwtq

 

Use a material called 'garloc' its green in colour, and available in many thickness's, I used the 1/16th stuff with no problems..Max

 

sweet i think NAPA has that stuff.

 

i say 402/393