High oil pressure w/ single set-up.
#1
silver ghost
Thread Starter
iTrader: (11)
Join Date: Sep 2003
Location: Home of the Rolex 24
Posts: 3,061
Likes: 0
Received 5 Likes
on
5 Posts
High oil pressure w/ single set-up.
I am noticing higher oil pressure w/ my single set-up as oppose to the old non-sequential twins. I am running the a-spec t4 35r kit w/ the restricter fitting on the feed side. It was 60-80 psi w/ load on the car. Now it pegs it a 100 psi. I am now leaking oil from the metering pump and one of my oil cooler fittings. Never leaked before and think its from the increased pressure tearing things up. Any suggestions? I am running and always have 20/50 vr1 oil. Thanks G
#3
"Elusive, not deceptive!”
How cold was it in Florida? Do you have an oil temp gauge?
My oil pressure goes to 110psi on start up. And that is with 10w30.
I try to us a low idle to keep it below 100psi till the oil temp gets to 70*C.
What else did you change with the single conversion? New oil pressure sending unit?
Barry
My oil pressure goes to 110psi on start up. And that is with 10w30.
I try to us a low idle to keep it below 100psi till the oil temp gets to 70*C.
What else did you change with the single conversion? New oil pressure sending unit?
Barry
#4
silver ghost
Thread Starter
iTrader: (11)
Join Date: Sep 2003
Location: Home of the Rolex 24
Posts: 3,061
Likes: 0
Received 5 Likes
on
5 Posts
How cold was it in Florida? Do you have an oil temp gauge?
My oil pressure goes to 110psi on start up. And that is with 10w30.
I try to us a low idle to keep it below 100psi till the oil temp gets to 70*C.
What else did you change with the single conversion? New oil pressure sending unit?
Barry
My oil pressure goes to 110psi on start up. And that is with 10w30.
I try to us a low idle to keep it below 100psi till the oil temp gets to 70*C.
What else did you change with the single conversion? New oil pressure sending unit?
Barry
Thread
Thread Starter
Forum
Replies
Last Post