Im going single and i tried to search for answer but couldnt get any ... im in the middle of installing single and fuel, and ect, i have blocked out everything and the selinoid rack also , and my question is there any write up on clipping the harness and tapping them up , the one that need to stay and the ones that need to be removed, i have my engine harness out of the motor, and now putting them back but i need to know what stays and what goes

thanks any would help

 

well...simple answer is to clip and tape everything you are not using.

emissions - two plugs for ACV, EGR sv, purge sv, air pump clutch

ECU - FPR sv, DT sv, SW sv, CRV sv, PC SV, WG sv, fuel temp

those are a few I though of off the top of my head...

ref. the work shop manual...I hope you have one handy.