darkphantom

iTrader: (2)

getting this turbo got a .96 A/r housing with a Qtrim for $900
got to see it in person & looks nice so your opinions









like i said. T66

bcty

that thign is gonna rip.. looks good

darkphantom

iTrader: (2)

hmm MY PICTURES WONT SHOW UP.

Carl Byck

peak hp@~6500 full boost @5500 500@25psi "THE WORD" Is it BB? Who did the manifold? any pics of the WG runner/main runner merge? Good drag turbo, you'll need to be above 4500 to get any sort of good response, but hold on when it hits

darkphantom

iTrader: (2)

always with the truth. Thanks again carl

Carl Byck

Don't get me wrong plenty of guys would run that on the street, just not me

twokrx7

iTrader: (1)

The housing was stamped ITS, it should be dual BB. I bet it spools pretty good for a T66 even with the q-trim, especially if the motor is ported.

iceman4357

iTrader: (2)

im getting a T78 put on with a freshly ported motor, think my spool characteristics will be similar?

Carl Byck

ITS makes BB, and Journal bearing. Is it water cooled? If not it is most likely not BB, although any configuration is possible. Either way it's a nice turbo. you said .96, so undivided with a divided manifold? It's not a big deal IMHO, vitually all Supras run an undivided hot side with what is obviously a divided manifold. I am not so familiar with T78s, i'd say a little later spool, but not much, remember boost is just a downshift away The port will make the difference. Carl ( off to the garage to bolt up my 67)