Custom Fuel Rails from the One and Only
#1
Rotary Enthusiast
Thread Starter
Join Date: Feb 2001
Location: The First State
Posts: 1,375
Likes: 0
Received 0 Likes
on
0 Posts
Custom Fuel Rails from the One and Only
crispeed has finally completed the Complete fuel rail kit for the FD. It utilizes 1600 secondary injectors and the stocck primaries. Because of people using different size fuel lines you must provide your fittings. The kit is sweet. Contact me if you need some as Chris is very busy building his car. Here is the pic
#7
So the primary rail is built to house the stock side feed injectors? I was hoping he would make a primary rail for top feed injectors so I can run all low impedance injectors.
Trending Topics
#8
Now that I am looking at the primary injector rail some more, it looks like it is made for top feed injectors. Could you double check this and let me know for sure? Thanks Greg!
#13
Haltech E6K
Join Date: Feb 2001
Location: Northern California (USA)
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
Why are the fittings not included? The (FD) stock lines are 5/16" and 99% of the people that convert over to SS braided lines use AN-6.
Are these going to be able to be shipped in a timely matter unlike the last rails he was advertising? I waited over 4-6 months for his rail and ended up making my own.
Are these going to be able to be shipped in a timely matter unlike the last rails he was advertising? I waited over 4-6 months for his rail and ended up making my own.
#15
Senior Member
Join Date: Aug 2001
Location: Tampa, Florida
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
I need one!!!!
Hey Greg.....I'm also wondering if they are both top feed....If not I guess I can deal with it but I'll have to wait for the price. Looks good though!!!
#25
Lives on the Forum
$399 Aussie?
The rail material is only like $15-$20 a foot.&nbp Get them cut down and you have about $30 worth of rail material.  Taps cost about $30 to thread the ends.  Brackets worth about $10 in scrap materials.  Bolt and fasteners about another $10.  The machined bungs are about $10 in scrap dowel pieces but require a machine lathe to turn out.  I see about $100 - $150 worh of stuff in that pic on the EXPENSIVE side!  All $ in U.S. dollars...
-Ted
The rail material is only like $15-$20 a foot.&nbp Get them cut down and you have about $30 worth of rail material.  Taps cost about $30 to thread the ends.  Brackets worth about $10 in scrap materials.  Bolt and fasteners about another $10.  The machined bungs are about $10 in scrap dowel pieces but require a machine lathe to turn out.  I see about $100 - $150 worh of stuff in that pic on the EXPENSIVE side!  All $ in U.S. dollars...
-Ted