Would 2 45 degree angles and a straight section be enough to weld together a custom DP for a single turbo?

 

Should be CLOSE... Not sure though. Maybe you can ask Ron?

 

For what manifold? I have an HKS Stainless that pretty much centers the exhaust housing between the ports and higher than the cast manifolds.. I wound up with ordering a pipe with 52 degree bends and it just about matches the slope of the tranny tunnel.

2 45s and some straight should fit in there depening on how your wastegate is situated.

 

When doing my dp, I whent to a exhaust shop and orderd one mandrel bent 3" "U" bend. Only cost $25. CJ