CSU/C&S 4barrel blow thru on 13BT?
CSU/C&S 4barrel blow thru on 13BT?
Has anyone ran a 4barrel blow thru carb on a 13BT with any degree of sucess?
They are commonly used on turbo V8s pushing out 4 figure bhp figures while keeping really good drivability and reliability, but a big capacity V8 is a whole different ballgame to us, so has anyone ran one on a little 13B Turbo before with any degree of success?
A friend has all the bits to make it a goer on his FB as he has parted out his turbo mustang, and although a lot of it is in the tuning, if its been tried and tested that a big power turbo rotary will never drive ok on a decent blow-thru 4barrel, I'll tell him its been tried and not worth it from the off.
They are commonly used on turbo V8s pushing out 4 figure bhp figures while keeping really good drivability and reliability, but a big capacity V8 is a whole different ballgame to us, so has anyone ran one on a little 13B Turbo before with any degree of success?
A friend has all the bits to make it a goer on his FB as he has parted out his turbo mustang, and although a lot of it is in the tuning, if its been tried and tested that a big power turbo rotary will never drive ok on a decent blow-thru 4barrel, I'll tell him its been tried and not worth it from the off.
Full Member
Joined: May 2003
Posts: 80
Likes: 0
From: durham nc
I'm using a blow-through carb on my Corolla. It works well on the street when properly tuned. I build my own carbs. This is a hp950 set up for e85.
Here's a couple of vids.
http://www.youtube.com/watch?v=lg6tzjYFMZs
http://www.youtube.com/watch?v=w0sD63uirOE
http://www.youtube.com/watch?v=7Xo8X2HXGvE
Here's a couple of vids.
http://www.youtube.com/watch?v=lg6tzjYFMZs
http://www.youtube.com/watch?v=w0sD63uirOE
http://www.youtube.com/watch?v=7Xo8X2HXGvE
Thread
Thread Starter
Forum
Replies
Last Post
danielbradley2
3rd Generation Specific (1993-2002)
11
Sep 28, 2015 10:44 PM
Devon300zx
2nd Generation Specific (1986-1992)
3
Sep 17, 2015 03:50 PM




