compressor upgrade kit..will it flow enough??
#1
Senior Member
Thread Starter
compressor upgrade kit..will it flow enough??
http://cgi.ebay.com/ebaymotors/ws/eB...e=STRK:MEWA:IT
i found this on ebay and seems reasonably priced. when i looked up the inducer and exducer sizes it looks to be a t5/6 wheel and compressor. seems slightly smaller than the bnr upgrades...dont they use the super h wheel and compressor?
i want to be able to hold 10 psi on stock ports efficiently... would this be adequate or should i hold off
i plotted the flow chart and it seemed to be alright,..or am i not getting something
thanks guys
zac
i found this on ebay and seems reasonably priced. when i looked up the inducer and exducer sizes it looks to be a t5/6 wheel and compressor. seems slightly smaller than the bnr upgrades...dont they use the super h wheel and compressor?
i want to be able to hold 10 psi on stock ports efficiently... would this be adequate or should i hold off
i plotted the flow chart and it seemed to be alright,..or am i not getting something
thanks guys
zac
#2
Racing Rotary Since 1983
iTrader: (6)
yes that's a Turbonetics T5/6 wheel. good for 43 lbs/minute.
pretty efficient around 1 bar of boost... on a very well ported/supported 13b it is capable of making (tops) 340 rw rotary hp. deduct for your stock ports etc...
i have never seen a compressor map for the wheel but there are maps for the S, V and H as well as the TO4E 40 and 46 wheels which are in the same neighborhood.
howard coleman
pretty efficient around 1 bar of boost... on a very well ported/supported 13b it is capable of making (tops) 340 rw rotary hp. deduct for your stock ports etc...
i have never seen a compressor map for the wheel but there are maps for the S, V and H as well as the TO4E 40 and 46 wheels which are in the same neighborhood.
howard coleman
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM