Been looking around for sometime now but cant find any suppliers. I see 1.0, and 1.10 available for the S360/363 but not for the s366.

Does anyone know where I can get hooked up?

 

Same a/rs are available for each unit....

1.10 is only necessary above the 25psi range on a S366 BTW.

.91 works fine on the S360 and S362( aka S363).

 

I dont see a 1.0a/r listed for the S366 from any of the common suppliers. Are you saying that the 1.0 /1.10ar turbine housings for the S360/S363 will fit the S366? If not, where can I get one?

 

i am going to run 18 psi on my 366 1.10AR. i thought all 300 series hotsides would fit

 

A year ago Tial announced they were going to start offering turbine housings for BW, but still haven't seen anything yet ....

 

Yes the 1.0 a/r turbine housing from the S360 or S363 will fit. (i cant see a 1.1 in their catalogue but it might exist) part number for the 1.0 a/r should be 177209.
link to BW catalogue here, you want page 40/41. http://www.3k-warner.de/files/pdf/BW...bo_Catalog.pdf

(i have not done this myself, but i have recently bought a BW S360 so have done lots of general reading on them. You may want to double or triple check before ordering. I would not want to be the one who steered you wrong! but I do believe the above is correct)

 

Borg Warner S300SX3 (68mm T/W) 1.00 A/R Turbine Housing 177209

 

For anything above 25 psi the 1.0 is good

 

^ I assume you meant below 25psi

 

Yes they do..! I have one (1.10 A/R) (1.0 A/R) and (0.91 A/R) for the BW-363 and BW-366 both have the same turbine diameter