BW S366 - Trying to find a 1.0 a/r or larger turbine housing. Do they even exist?
Been looking around for sometime now but cant find any suppliers. I see 1.0, and 1.10 available for the S360/363 but not for the s366.
Does anyone know where I can get hooked up? |
Same a/rs are available for each unit....
1.10 is only necessary above the 25psi range on a S366 BTW. .91 works fine on the S360 and S362( aka S363). |
Originally Posted by Turblown
(Post 11813759)
Same a/rs are available for each unit....
1.10 is only necessary above the 25psi range on a S366 BTW. .91 works fine on the S360 and S362( aka S363). I dont see a 1.0a/r listed for the S366 from any of the common suppliers. Are you saying that the 1.0 /1.10ar turbine housings for the S360/S363 will fit the S366? If not, where can I get one? |
i am going to run 18 psi on my 366 1.10AR. i thought all 300 series hotsides would fit
|
A year ago Tial announced they were going to start offering turbine housings for BW, but still haven't seen anything yet ....
|
Originally Posted by jetlude
(Post 11813856)
I dont see a 1.0a/r listed for the S366 from any of the common suppliers. Are you saying that the 1.0 /1.10ar turbine housings for the S360/S363 will fit the S366? If not, where can I get one?
link to BW catalogue here, you want page 40/41. http://www.3k-warner.de/files/pdf/BW...bo_Catalog.pdf (i have not done this myself, but i have recently bought a BW S360 so have done lots of general reading on them. You may want to double or triple check before ordering. I would not want to be the one who steered you wrong! but I do believe the above is correct) :nod: :icon_tup: |
|
For anything above 25 psi the 1.0 is good
|
^ I assume you meant below 25psi
|
Yes they do..! I have one (1.10 A/R) (1.0 A/R) and (0.91 A/R) for the BW-363 and BW-366 both have the same turbine diameter
|
All times are GMT -5. The time now is 08:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands