Boost controller ?`s
#1
Rotary Enthusiast
Thread Starter
Join Date: Oct 2001
Location: Canada
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
Boost controller ?`s
I read this under the search section:
"for the boost controller it should be routed to a non vac boost source..ie right after the compressor housing.. not on the uim or lim"
I have the Apex single turbo and the HKS evc ez boost cont. Can I tee into the same boost source for the valve controller, the one reads boost and the other t`s into the the wastgate. The problem is that the apex turbo and my piping does not have a boost source that is non vac before the uim,or the lim. Can I use the line that is on the back side of the throttle body?
The waste gate has never opened yet even with the boost turned to the lowest setting. I have pushed it to 1.2 Bar but dont want to go any higher.
Another quick ? should I set the My power FC at 1.2 bar so I dont hit fuel cut or higher?
Steve
"for the boost controller it should be routed to a non vac boost source..ie right after the compressor housing.. not on the uim or lim"
I have the Apex single turbo and the HKS evc ez boost cont. Can I tee into the same boost source for the valve controller, the one reads boost and the other t`s into the the wastgate. The problem is that the apex turbo and my piping does not have a boost source that is non vac before the uim,or the lim. Can I use the line that is on the back side of the throttle body?
The waste gate has never opened yet even with the boost turned to the lowest setting. I have pushed it to 1.2 Bar but dont want to go any higher.
Another quick ? should I set the My power FC at 1.2 bar so I dont hit fuel cut or higher?
Steve
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM