Boost Controll problems
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Castle Rock Washignton
Posts: 596
Likes: 0
Received 0 Likes
on
0 Posts
Boost Controll problems
Alright I have a 93 rx7 with a t-70 and a hks gt waste gaste hks III evc and a BUNCH of other crap... It has the hard green and red spring in the waste gate... I have the waste gate adjusted damn near all the way out... for a while it seemed to have ran find between 11-15 lbs of boost... did it for about 2 days now I am hitting 18 psi... notmatter if my boost controller is on or not... right now i have it set at .90 with over boost at 1 bar...
I wonder if I switched up my lines putting the boost controller in... on the hks gt waste gate which vaccume port is going to be my primary actuator and which is going to be my secondary actuator????
I wonder if I switched up my lines putting the boost controller in... on the hks gt waste gate which vaccume port is going to be my primary actuator and which is going to be my secondary actuator????
#3
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
THINK of it this way.
If it has been running fine for two years and you have not changed anything, then something has changed on it's own.
What can that be? Somthing is leaking or has come loose or has gone bad.
What can that be? Hoses, connectors, WG diaphram, or boost controller.
Get to it and check them out!
If it has been running fine for two years and you have not changed anything, then something has changed on it's own.
What can that be? Somthing is leaking or has come loose or has gone bad.
What can that be? Hoses, connectors, WG diaphram, or boost controller.
Get to it and check them out!
#4
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Castle Rock Washignton
Posts: 596
Likes: 0
Received 0 Likes
on
0 Posts
Everything is hooked up and tight... I even took the wastegate off to look for a ripped diaphram and to see what kind of spring is in it... but it was only running right for 2 days not 2 years
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM