Anyone Using E-Boost Street with a 4 Port Solenoid?
Thread Starter
Joined: Feb 2001
Posts: 7,941
Likes: 133
From: In A Disfunctional World
Anyone Using E-Boost Street with a 4 Port Solenoid?
With the stock 3 port solenoid, my 12 psi boost settings and response are good and like the manual states.
But at 18 psi, I have to set Gate Pressure down to 1 psi to limit spiking to about +.5 psi. Any higher spiking gets worse.
This hurts spool-up.
If using a 4 port, how is your spoolup?
But at 18 psi, I have to set Gate Pressure down to 1 psi to limit spiking to about +.5 psi. Any higher spiking gets worse.
This hurts spool-up.
If using a 4 port, how is your spoolup?
Thread
Thread Starter
Forum
Replies
Last Post
badass7
Engine Management Forum
1
Jan 31, 2002 02:47 PM