Anyone used HKS racegate knock offs?
#1
Stay back** Open flames
Thread Starter
iTrader: (6)
Join Date: Mar 2003
Location: Bay Area, Ca
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
Anyone used HKS racegate knock offs?
ie: http://cgi.ebay.com/ebaymotors/ws/eB...906538769&rd=1
cheap, looks like an hks, but what about functionality? if it's copied directly off HKS's design, how bad could it be? Any feedback would be appreciated, and these are significantly cheaper (ie. half the cost of the HKS racegate)
cheap, looks like an hks, but what about functionality? if it's copied directly off HKS's design, how bad could it be? Any feedback would be appreciated, and these are significantly cheaper (ie. half the cost of the HKS racegate)
#2
Lives on the Forum
iTrader: (126)
Re: Anyone used HKS racegate knock offs?
Originally posted by wotary
ie: http://cgi.ebay.com/ebaymotors/ws/eB...906538769&rd=1
cheap, looks like an hks, but what about functionality? if it's copied directly off HKS's design, how bad could it be? Any feedback would be appreciated, and these are significantly cheaper (ie. half the cost of the HKS racegate)
ie: http://cgi.ebay.com/ebaymotors/ws/eB...906538769&rd=1
cheap, looks like an hks, but what about functionality? if it's copied directly off HKS's design, how bad could it be? Any feedback would be appreciated, and these are significantly cheaper (ie. half the cost of the HKS racegate)
i think davinci uses this one with their kit
#3
I heard the HKS knockoffs had problems holding boost under 1bar, but above that it was perfectly ok. Just keep in mind theres usually a reason their cheaper other than j/ a brand name.
#4
Rotary Enthusiast
isnt ssautochrome the same place that sells those obx headers that r just plain a piece of crap???
i don`t know man ,.....not that i am going after that brand is better crap but usually they are
i don`t know man ,.....not that i am going after that brand is better crap but usually they are
#5
Stay back** Open flames
Thread Starter
iTrader: (6)
Join Date: Mar 2003
Location: Bay Area, Ca
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
I was just wondering - i ordered a tial 44mm wg for myself from cheapturbo.com. I just see them all over the place, and as long as the machining is dead on, it would theoretically function ok...
guess not
guess not
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM