Aftermarket Coils - Blaster HVC with stock ignitors?
#1
Hot Dicken's Cider
Thread Starter
iTrader: (2)
Join Date: May 2003
Location: Marion, Ohio
Posts: 1,428
Likes: 0
Received 0 Likes
on
0 Posts
Aftermarket Coils - Blaster HVC with stock ignitors?
So I've got two MSD blaster HVC coils sitting here that I want to use as an upgrade to my leading coils. How should I go about wiring these up? Can I just run the two wires from my stock leading coil ignitor or do I have to use 6A boxes?
Last year I just ran stock T2 ignition with no problems, but this year I'm going to need an upgrade. It is getting tuned this friday, so I am short on time.
Thanks
Last year I just ran stock T2 ignition with no problems, but this year I'm going to need an upgrade. It is getting tuned this friday, so I am short on time.
Thanks
#3
Banned. I got OWNED!!!
Join Date: Jan 2002
Location: Cincinnati, OH
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Ok the FC module goes into trailer coil and the FD module goes into both leader coils. And make sure they fire at the same time, every time.
Also make damn well sure you ground the coils properly. To the earth.
Also make damn well sure you ground the coils properly. To the earth.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM