2 T78's
Is that you John Wayne?
Joined: Mar 2001
Posts: 871
Likes: 0
From: Japan
Your best bet would be to use twin TDO6-25G's or a Garrett hybrid T4/T3. HKS GT series turbos are nothing more than T4/T25(GT25) and T4/T3(GT28 and GT30) with a BB center section. The ex housings have HKS specific flanges but the overhaul designs are derived from the non-BB Garretts. A GT3240 is a BB T04S/T3 and the GT3540 has a range that goes from T04R/T3 to straight T04R. The Greddy T67-25G is also a good turbo for high hp twin setups over here.
Persona non grata
Joined: Feb 2001
Posts: 2,487
Likes: 17
From: Ballwin, MO
Originally posted by Rx7 TwinTurbo
Hey Ted I can assure u i do my HW.I have spent close to 35 grand on my 20 grand FD so I know a thing or 2 about it.Then there is the thing about the 13b.I never said I ran a 13b.You might find this hard to believe but I have a lot of money to spend on tuning so I went to Britain for a little tuning job from HME.Hurley Motor Engineering installed their latest creation.A 4 rotor TT sequential machine.I currently run 10.2 on the quarter at 736Hp and 578TQ.This is where you can check out HME (http://www.hurley-engineering.ltd.uk/).The engine cost me $13,000.The stock Turbos were used and 3mm Apex seals complete the package.Of course this engine requires more air so an Apex GTI was added and 2 Apex intakes.I have been doing this for a while so don't talk about homework with me.
Hey Ted I can assure u i do my HW.I have spent close to 35 grand on my 20 grand FD so I know a thing or 2 about it.Then there is the thing about the 13b.I never said I ran a 13b.You might find this hard to believe but I have a lot of money to spend on tuning so I went to Britain for a little tuning job from HME.Hurley Motor Engineering installed their latest creation.A 4 rotor TT sequential machine.I currently run 10.2 on the quarter at 736Hp and 578TQ.This is where you can check out HME (http://www.hurley-engineering.ltd.uk/).The engine cost me $13,000.The stock Turbos were used and 3mm Apex seals complete the package.Of course this engine requires more air so an Apex GTI was added and 2 Apex intakes.I have been doing this for a while so don't talk about homework with me.
. That is so obvious BS it is not funny.
Full Member
Joined: Feb 2002
Posts: 71
Likes: 0
From: baltimore, md - harrisburg, pa
Re: 2 T78's
Originally posted by Rx7 TwinTurbo
Is it even possible to mount 2 T78 or 88 turbos,or any 2 aftermarket turbos.And if it is,why doesn't anyone do it.
Is it even possible to mount 2 T78 or 88 turbos,or any 2 aftermarket turbos.And if it is,why doesn't anyone do it.
Thread
Thread Starter
Forum
Replies
Last Post