Emmission removed, using resistors on solenoids
#1
Emmission removed, using resistors on solenoids
on my 93 fd I removed all emmissions using banzai block off plates and pineapple idler pulley, I used 330 ohm resistors for the plugs on the rats nest that aren't used anymore to prevent CEL, but the info I couldn't find is what do I do with the plugs that actually plugged into the air pump, AWS, etc? Do I just leave them unplugged or do I put the resistors on there as well? Ive researched extensively and can't find an answer. It's the plugs that go to the emmissions in the pics below---
#3
Full Member
iTrader: (2)
Join Date: Feb 2015
Location: Florida
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Well, it depends what you are after. Leaving them unplugged will not hurt anything, but it will probably throw a CEL. It won't put it into limp mode or anything through. I have all my emissions stuff removed with out resistors since I had the same problem as you; I simply removed my CEL bulb in the cluster since I live in a state that doesn't test for emissions.
Thread
Thread Starter
Forum
Replies
Last Post
Gen2n3
2nd Generation Specific (1986-1992)
1
09-07-16 05:15 PM