What did you to or with your RX-7 Today?
#79
I can't see my car **(
iTrader: (16)
Godspeed knock off greddy FMIC and some 60mm evo-r's
Now to bondo the 2 rust spots in the sunroof and it will be set for a sealer and vinyl wrap. Throw on a pfc to turn the boost back up and eat some v8s, only boosting 8-7-9 right now will throw one newer injectors and do 12-(10-11)-12 mildly street ported so should be ~335 wheel.
Now to bondo the 2 rust spots in the sunroof and it will be set for a sealer and vinyl wrap. Throw on a pfc to turn the boost back up and eat some v8s, only boosting 8-7-9 right now will throw one newer injectors and do 12-(10-11)-12 mildly street ported so should be ~335 wheel.
Last edited by Ruler_Mark; 11-03-10 at 05:35 PM.
#80
got my mazdaspeed oil cap today and slapped on a new power steering system in my FD cause the bearings were bad & a new idle pulley cause it had the same problem & on top of that got my black BOV spring on to my tiAL Q BOV so now it finally works good day today a lot accomplished
#81
Godspeed knock off greddy FMIC and some 60mm evo-r's
Now to bondo the 2 rust spots in the sunroof and it will be set for a sealer and vinyl wrap. Throw on a pfc to turn the boost back up and eat some v8s, only boosting 8-7-9 right now will throw one newer injectors and do 12-(10-11)-12 mildly street ported so should be ~335 wheel.
Now to bondo the 2 rust spots in the sunroof and it will be set for a sealer and vinyl wrap. Throw on a pfc to turn the boost back up and eat some v8s, only boosting 8-7-9 right now will throw one newer injectors and do 12-(10-11)-12 mildly street ported so should be ~335 wheel.
#82
A.K.A. LuisGT
Replaced the lsd 4.77(broken) with another lsd 4.77 that wasn't locked up on my SA, and upgraded the tranny to a 2600i 5speed using rx4 bellhousing and scatter shield, installed new driveshaft from advance driveline in Orlando, Fluids tomorrow and then a good ole test drive.