I'm using the atp input for an aem uego and it logs and reads fine on the palm but when I view the logs on the pc it's displayed as voltage not afr. How do I change it? I searched but haven't been able to find anything on it.

Brent

 

Preferences-> Custom Sensors -> analog input 1

 

Turns out it was a problem with the palm, it didn't hold the setting on AEM uego for some reason. That's why I was getting the voltage only.

Brent

 

I am very confused. You said when you view the logs on a PC, it shows volts. Then you said it was a palm problem. The instructions I gave you are for setting up the scaling in the PLViewer (PC). The settings in the palm for scaling are not carried over to the PC.

 

You and me both. Forget my post above, i was confused. I realize now that the scaling in the palm is not carried over and that you need to input the #'s according to the range of the o2 sensor that your using. It's working fine now thanks for your patience.

Why is it every time I go to the ext. sensor set up in the palm it always shows
tech edge when I've selected aem? Don't get me wrong, it's working fine but why doesn't it show that it set to aem if you go back to it?

Brent

 

the only important thing is that the numpers on the multiplier and the offset stay the same. the name of the wideband wont stay, dont ask me why.

 

Sorry guys, I guess it's not clear enough.

The pulldown is just to put the presets into the multiplier and offset values. i.e. if you choose aem from the pulldown, it puts the correct numbers in below. The next time you go to that screen, the numbers are still there, but the menu resets to the first position. It does not remember what preselect you chose, only the numbers. Preselects are only moved into the M&O values when you open the pulldown and select something. What the pulldown shows any other time has no meaning.

 

Thanks.

 

It threw me off originally because the manual that I viewed online displayed it differently than my palm.

Brent