ok...when i bought my car, the previous owner had put rtek2.0 on it:
came with upgraded rtek 2.0 ecu and hotsync cables.
didnt have the PDA so i just ordered a Palm IIIc.

ive been looking at pocketlogger.com but all i see is the rtek package for
the rx7 for like $400.

i just need the software so i was wondering where or how i could get it to be
able to use the PDA with my car.

 

You do this by entering a post in the RTEK section or reading the instructions at Digital Tuning ........or calling Digital Tuning on the phone...........or E-Mailing Digital Tuning.

OR downloading the instructions for the RTEK 2.0 Turbo and reading page 41 of that document. Download from Digital Tuning. http://digitaltuning.com/instruction...cketlogger.pdf

Appendix II

 

www.digitaltuning.com/software/rtek.zip

Try that, make sure its build 4...

 

thanks.

 

will this software work with mine? i have an rtek 2.0 ecu, my car is an 88 gxl.

 

That software works with all Rtek stage 2 ECUs.

 

thanks i also wanted to know is it ok to install the rtek ecu on a stock engine or should i wait until i half bridge it?

 

The ecu is stock when it comes back from us, so yes it runs stock cars perfectly.

 

ok that sounds good only one problem i bought the unit used, so its probably been set for there car. can i just input the stock settings / download a stock setup to my palm and run it? thanks

 

Please read the last question in the FAQ.