Engine Studs, Heres what I see on the Mkt & What do you run?
#76
Rx2 > FD
iTrader: (10)
I'm curious to know if adding a larger diameter stud/tension bolt or solid dowel in the area where the I beam is pointing to would better than other areas. I see Goopy adds 5 larger diameter bolts, but they do not have one in that area.
I have also seen dowels above and below that area. But not on that specific tension bolt hole. Maybe because removing material from there weakens it. But reinforcing the area around it gives the rigidity needed?
I have also seen dowels above and below that area. But not on that specific tension bolt hole. Maybe because removing material from there weakens it. But reinforcing the area around it gives the rigidity needed?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM