Water injection requirements (fd)
#1
Cant be bothered anymore
Thread Starter
Join Date: Aug 2004
Location: Norwich UK
Posts: 465
Likes: 0
Received 0 Likes
on
0 Posts
Water injection requirements (fd)
What percentage water to fuel ratio do you guys run. I have the cooling mist 2 stage kit with 1x 1gph and 1x3.9gph jet. Now gonna increse my fuel supply and was thinking of getting a controller for the WI so it can be metered in. I was gonna work on 15% max water ratio.
Scott
Scott
#2
Old [Sch|F]ool
You can run up to 2:1 water/fuel, theoretically. That's about the point where combustion ceases.
Water injection isn't rocket science. You inject enough water to keep it from detonating, and there is a VERY broad spectrum between "enough" and "too much".
Water injection isn't rocket science. You inject enough water to keep it from detonating, and there is a VERY broad spectrum between "enough" and "too much".
#4
I'll blow it up real good
iTrader: (1)
Any where from 10% to 20% so 15% sounds good to start with. Check out this forum if you haven't already:
http://www.aquamist.co.uk/phpBB2/index.php
Anything much more than 20% water you will begin to get breakup.
Also, you need a really good ignition system to spark the mixture.
http://www.aquamist.co.uk/phpBB2/index.php
Anything much more than 20% water you will begin to get breakup.
Also, you need a really good ignition system to spark the mixture.
#5
Cant be bothered anymore
Thread Starter
Join Date: Aug 2004
Location: Norwich UK
Posts: 465
Likes: 0
Received 0 Likes
on
0 Posts
Cheers. I was thinking along those lines. Now starting to wonder if its possible to place a jet pre turbo on my stock twin after reading the WI forum
Scott
Scott
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM