ok,so i decided to use the rx8 stationary gears on my big port s4 t2.my question is,since the rx8 stationary gears use the FD thrust bearings.do i need to buy them?because im using the 8.5:1 s4 rotors/counter weight.would it make a difference to use the s4 thrust bearings?or do i have to buy the FD thrust bearings?

 

bump

 

come on i know someone has run FD stationary gears on a s4.im just asking how....

 

I have run a similar setup using high compression rotors with Turbo II outer cast irons and a 12A center cast iron. The front/rear stationary gears were from a 1993 engine I had in my garage. It will work you just have to use the entire front assembly.

Good Luck

Albert

 

im in the same boat rite now and that whole 12a hybrid totaly threw me off. is there anybody that can shine some light on how to use the rx8 or S6 gears in the S4 T2 motor?