Someone Take Over my Project...
Joined: Oct 2001
Posts: 6,444
Likes: 0
From: Fort Branch, Indiana
Greg I know exatly how you feel man... I got about 10k in my Cosmo POS 
It needs to be tuned, which I cant find anyone within a 1000 miles ONE WAY to do it. #2 I got thinking about if Id done a LS1 6 speed swap I would have been done, and when tuning needs arised I could have drove 5 miles and had it done. Had the same amount money in it and same horsepower... Wellanyways, I wouldnt be any different trying ot beat v8's w/o a rotary than everyone else out there, so I went rotary...
The other nite, I played with the tuning on the haltech, and it started to run a little better and I smiled, then it started taking a oil **** all over everything... I almost cried ! So man I feel your pain... But someday the sun will shine, and some Mustangs are gonna get an *** kickin'!!!
It needs to be tuned, which I cant find anyone within a 1000 miles ONE WAY to do it. #2 I got thinking about if Id done a LS1 6 speed swap I would have been done, and when tuning needs arised I could have drove 5 miles and had it done. Had the same amount money in it and same horsepower... Wellanyways, I wouldnt be any different trying ot beat v8's w/o a rotary than everyone else out there, so I went rotary... The other nite, I played with the tuning on the haltech, and it started to run a little better and I smiled, then it started taking a oil **** all over everything... I almost cried ! So man I feel your pain... But someday the sun will shine, and some Mustangs are gonna get an *** kickin'!!!
Joined: Oct 2001
Posts: 6,444
Likes: 0
From: Fort Branch, Indiana
Originally posted by vosko
you need a trans to start the car. where does the starter go ????? jeez
you need a trans to start the car. where does the starter go ????? jeez
MY cosmo 13b came complete with a starter and no tranny... And I did a compression check on it. The starter mounts to the side of the motor on this one
Thread
Thread Starter
Forum
Replies
Last Post
80's old school
1st Gen General Discussion
18
Aug 6, 2010 11:38 PM