side seal end gap, shud i tighten it up?
#1
Racing Rotary Since 1983
Thread Starter
iTrader: (6)
side seal end gap, shud i tighten it up?
i have a 200 mile from new motor ( race port w 80 lbs minute worth of turbos and all the supporting systems) open and am wondering if it would be worthwhile to tighten up the sideseal/cornerseal gap from where it currently is at 3 thou.
if i tightened it to 1 thou would i see any measurable difference on a compression test... or inches of mercury at idle, or hp/torque.
if so, how much?
howard coleman
if i tightened it to 1 thou would i see any measurable difference on a compression test... or inches of mercury at idle, or hp/torque.
if so, how much?
howard coleman
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM