Ported UIM and TB
Thread Starter
boxed in and drawn out
Joined: Dec 2003
Posts: 555
Likes: 0
From: Bayouself
Ported UIM and TB
Something I did about 7months ago and am puuting the car together.
Do not know if I will realize any improvements but what the heck.
L.I.M. is ported also.
Goes with TO4R 1.00 ported & divided .
3.5 down and back.
The TB is as big as can be made without hurting the shaft movement. The primary was ported to the OE secondary and I used one O.E. secondary butterfly as the new primary one.
I dont have the mill specs cause this too was done last year.
Do not know if I will realize any improvements but what the heck.
L.I.M. is ported also.
Goes with TO4R 1.00 ported & divided .
3.5 down and back.
The TB is as big as can be made without hurting the shaft movement. The primary was ported to the OE secondary and I used one O.E. secondary butterfly as the new primary one.
I dont have the mill specs cause this too was done last year.
Thread Starter
boxed in and drawn out
Joined: Dec 2003
Posts: 555
Likes: 0
From: Bayouself
I am next to New Orleans no power ( at the garage)... People are moving here. Thanks for the nice words .I will post when I can finish. Got to get my business back up and going 1st.
Thread
Thread Starter
Forum
Replies
Last Post
Steelwheelz
2nd Generation Specific (1986-1992)
6
Sep 15, 2015 03:22 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
