Pics of Secondary PeriPorts in progress
#1
Rotary Enthusiast
Thread Starter
Join Date: Feb 2001
Location: The First State
Posts: 1,375
Likes: 0
Received 0 Likes
on
0 Posts
Pics of Secondary PeriPorts in progress
here are some pics I took today of the semi periphial port that hector is making for InitialD FCs car. Its still not done yyet but here ya go. The glue used is top nitch ****. Hector uses this on the rotorhousings also. Check em out
#5
Has he ever done that befor? My friend tried a hole bunch of stuff with combination, p port and stock ports, but they never ran right. I don't know mabe he has a good method. I want to see some pics of the rotor housings, do you have any? Also is that stuff 2 in. OD? Looks good though. Why not JB that stuff works great?
CJG
CJG
#6
Rotary Enthusiast
Thread Starter
Join Date: Feb 2001
Location: The First State
Posts: 1,375
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Rotortuner
Has he ever done that befor? My friend tried a hole bunch of stuff with combination, p port and stock ports, but they never ran right. I don't know mabe he has a good method. I want to see some pics of the rotor housings, do you have any? Also is that stuff 2 in. OD? Looks good though. Why not JB that stuff works great?
CJG
Has he ever done that befor? My friend tried a hole bunch of stuff with combination, p port and stock ports, but they never ran right. I don't know mabe he has a good method. I want to see some pics of the rotor housings, do you have any? Also is that stuff 2 in. OD? Looks good though. Why not JB that stuff works great?
CJG
Trending Topics
#9
Old [Sch|F]ool
I heard about some rally racer in NZ who put normal peripheral port housings (HUGE) in with normal side port housings, and ran a 45DCOE to the side ports and a 48IDA to the p-ports, and put staged linkage on there... so at low power/throttle position it ran on the side ports and the 45DCOE, then at heavy throttle it worked off of both the 45DCOE AND the 48IDA going to the p-ports... supposedly it made stupid-big power but tuning it must have been a total bitch!
ok but anyway... big ports and crappy idles are cool.
ok but anyway... big ports and crappy idles are cool.
#11
20B N/A Wide Body FC3S
Why not just weld the manifold... I realize that it is cast aluminum, but I see people here in Japan weld aditional injector bungs to them all day long with no problems... I'd just be worried about the heat from the turbo on the lower manifold. All that expansion and contraction especially on aluminum would eventually crack the glue unless it expands and contracts at the same rate as the aluminum around it...
but way cool non the less..
but way cool non the less..
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM