Dyno results to come
Dyno results to come
I have a first gen rx7 with twin non-sequential TO4 turbos, Haltech F9 ECU, extend port,Holley Annihilator ignition, 3"Mandrel exhaust, High flow muffler, turbosmart dual stage boost controller, Toyota Supra 5 speed box, 3" 5mm wall thickness drive shaft.
NA it produced 170 RWHP and ran a 14.02.
I have since done all the mods and am planning to run between 18 to 24 PSI boost. I will be dynoing it in the next few weeks, so i'll see how it goes.
I also have a 50-400Hp NOS kit to fit to it, but i'll only give it about 100 shot if needed.
I'm not interested in predicting what HP it will or should make so i will post the results when they are available.
NA it produced 170 RWHP and ran a 14.02.
I have since done all the mods and am planning to run between 18 to 24 PSI boost. I will be dynoing it in the next few weeks, so i'll see how it goes.
I also have a 50-400Hp NOS kit to fit to it, but i'll only give it about 100 shot if needed.
I'm not interested in predicting what HP it will or should make so i will post the results when they are available.
Originally posted by silverrotor
A FB Turbo with NOS. I can Imagine It now....You are probably the first of It's kind that I have heard. Wait a minute, you are.
Keep us posted.
A FB Turbo with NOS. I can Imagine It now....You are probably the first of It's kind that I have heard. Wait a minute, you are.
Keep us posted.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM



