Apexi SAFC Missing harness Help!!!
#1
Full Member
Thread Starter
Join Date: Dec 2001
Location: Fresno, CA
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
Apexi SAFC Missing harness Help!!!
What do I do if I'm missing the harness for the SAFC. It's the piece that connects the protruding wires to the ecu. Is it essential for operation or can I just splice? If I need it, where can I get one?
#3
Full Member
Thread Starter
Join Date: Dec 2001
Location: Fresno, CA
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
Ok I am not explaining myself very well... There is the AFC, a Wire, a little HArness about 1.5"x.8" that I have. It is my understanding that there is another section of wire that connects to that section to give you room to install it, I understand you have to splice it but at this point its onlly about 14" of total wire... basically in a basic diagram:
[SAFC]----------{ }----------- <- need this section
|
....................end of what I have
BTW, Thanks for the GReat Service Jason.....
M. Landy
[SAFC]----------{ }----------- <- need this section
|
....................end of what I have
BTW, Thanks for the GReat Service Jason.....
M. Landy
Last edited by BuddyRX7; 01-02-02 at 08:57 PM.
#6
Rotary Freak
Join Date: Feb 2001
Location: Okinawa, Japan
Posts: 2,149
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 10:46 PM