20B into a B2200
#1
Full Member
Thread Starter
Join Date: Aug 2002
Location: Abilene, Tx
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
20B into a B2200
My brother and I have acquired a 20B and he has a 1990 B2200 with a bad motor in it. He has been wanting to put some sort of rotary in it and now that we have the 20B that is what he wants to do. My search results found that about 2 years ago someone asked the same question and there were not a lot of answers. I am asking has this been done?? Or is it just unrealistic?? I would like some truthful opinions. Thanks in advance.
Tyler
Tyler
#4
Rotary Enthusiast
Join Date: Nov 2003
Location: Canada
Posts: 814
Likes: 0
Received 0 Likes
on
0 Posts
It has been done by a handfull around the world. I know Marcos Acosta put a 4-rotor in a B2200, but that was a pro-class drag truck.
I don't think it would be any harder than putting it into an RX-7.
I don't think it would be any harder than putting it into an RX-7.
Trending Topics
#8
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,844
Received 2,606 Likes
on
1,849 Posts
we did one, using a b2600 2wd and a cosmo front cut. the engine is a little long to fit the bay, but it does fit. you have to make your own mounts etc. all the stock cosmo stuff fits in the truck engine bay although its a tight sqeeze.
the truck breaks the right rear tire loose at 4500rpm in the 1st 3 gears
the truck breaks the right rear tire loose at 4500rpm in the 1st 3 gears
#9
I'll blow it up real good
iTrader: (1)
Originally posted by j9fd3s
we did one, using a b2600 2wd and a cosmo front cut. the engine is a little long to fit the bay, but it does fit. you have to make your own mounts etc. all the stock cosmo stuff fits in the truck engine bay although its a tight sqeeze.
the truck breaks the right rear tire loose at 4500rpm in the 1st 3 gears
we did one, using a b2600 2wd and a cosmo front cut. the engine is a little long to fit the bay, but it does fit. you have to make your own mounts etc. all the stock cosmo stuff fits in the truck engine bay although its a tight sqeeze.
the truck breaks the right rear tire loose at 4500rpm in the 1st 3 gears
#10
Full Member
Thread Starter
Join Date: Aug 2002
Location: Abilene, Tx
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Anyone know where I could get a rebuild kit for the 20B at??
j9fd3s-- What did you use for the driveshaft??
Right now we are talking about just using a cosmo tranny and rear end.
j9fd3s-- What did you use for the driveshaft??
Right now we are talking about just using a cosmo tranny and rear end.