I've been lookin all over this forum for the thread that had the install instrucitons for the PFC but can't seem to find it :/. Like correct wires to cut. I wasn't gonna at first, but I think I'm gonna break the prongs on the ECU side. If anyone has a picture showing the ECU side with the right ones to remove that would be greatly appreciated.

Thanks,
Jason

 

This is what I found: https://www.rx7club.com/power-fc-forum-47/noob-question-491206/
But I couldn't find anyone to confirm the wires.... I'm planning on pushing the connector pins in the wiring harness out so I don't have to mess with cutting wires or breaking pins on the ECU. Hope this helps!

Found more info:
http://westpenn.rx-7.org/ApexiPFCpinout.htm

https://www.rx7club.com/power-fc-forum-47/how-pulling-pins-ecu-connector-424626/

The second diagram confirms my first post about the wires. Amazing what you find when you search, I could have sworn I already did, lol.

 

Yeah, I think the WestPenn one is the one I was looking for. I remember reading about wire cutting directions that came with a few PFC's that were incorrect. I guess I will just push out the wire for now til I know for sure on which pins to cut.