Thanks for the info, I will research it some more, but would still like to know where everyone gets the 3 Bar Denso units from!?!?!?

 

4 bar greddy map sensor is also plug and play, except you have to move 2 of the wires in the plug and enter the correct scale and offset. I have calibrated mine so I have the correct S/O.

 

got mine from ari at rx7.com it came out for 170 shipped.

 

greddy 4 bar:
https://www.rx7club.com/showthread.p...ghlight=greddy

part number: 16401301
cost: $115 +/-

Switch the white and black pins around with each other in the connector.(plugs in just like stock)
Scale 9300 and offset 4500

I guess the commander by itself doesn't allow for scale and offset changes to be made? So the datalogit would have to be used to make the changes for most aftermarket map sensors.

 

Ok so after lack of feedback on the Denso/Apexi unit, my buddy and I went with the GM 3 Bar unit and harness from Banzai...Thanks to those that replied!!!