Power FC Using PFC for troubleshooting
#1
Using PFC for troubleshooting
hey all,
I have access to a friend of mine's PFC and commander. I was wondering if I could use the sensor check function to check all my sensors at once, rather than going through, and pulling them out one by one. I am not getting any codes from the ECU, and i think my ECU is in limp mode and wont reset. I was thinking I could use the PFC as a shortcut to help me troubleshoot. Would this work?
thanks!
neil
I have access to a friend of mine's PFC and commander. I was wondering if I could use the sensor check function to check all my sensors at once, rather than going through, and pulling them out one by one. I am not getting any codes from the ECU, and i think my ECU is in limp mode and wont reset. I was thinking I could use the PFC as a shortcut to help me troubleshoot. Would this work?
thanks!
neil
Thread
Thread Starter
Forum
Replies
Last Post